Peavey BAM 210 Operación Manual página 76

Address
(Hex)
00
01
02
03,04
05,06
07,08
09,0A
0B,0C
0D,0E
0F,10
11,12
13,14
15
16
17
18-1D
1E
Values are automatically set with effect selection, adjust after to tweak. Available tweaks are shown in table below.
Chorus
Flanger
Phaser
Octave
Synth
Fretless
Funk Wah
Distortion
PRESET DEFINITION
Name
Model Selection
Hardware Control Bits
<reserved>
Pre Gain (non-boost, boost)
Low (non-boost, boost)
Mid (non-boost, boost)
Mid Shift (non-boost, boost)
High (non-boost, boost)
Post Gain (non-boost, boost)
<reserved>
Speed/Adj (primary/off, secondary/on)
Depth (primary/off, secondary/on)
Effect Type
Effect Tweak 1
Effect Tweak 2
<reserved>
EFX Mode Status Bits (Soft)
Tweak 1
-
Delay Time
-
Tone
Frequency
Frequency
Frequency
Low Rolloff
76
Range (Decimal)
High nib is Cabinet Model, 0-7
Low nib is Amp Model, 0-7
Clockwise rotation for both nibs:
0 = Red / 2x10
1 = 360 / 1x18
: : :
7 = Freddie K / Alloy 4x10
0-3,7 = <reserved>
4 = Compressor On
5 = Analog Overdrive On
6 = Tweeter On
0
1-33 (active when Analog Overdrive
enabled)
1-33
1-33
1-33
1-33
0-33 (0 = reverb off)
0
1-25
0-25 (0 = modulation off)
0-7 = Chorus, Flanger, Phaser,
Octave, Synth, Fretless, Funk Wah,
Distortion
1-25; 255=no tweak *(see below)
1-25; 255=no tweak *(see below)
0
High nib is <reserved>
Low nib is EFX mode status:
Bit 0 is Boost (on/secondary = high)
Bit 1 is <reserved>
Bit 2 is Effect On (on = high)
Bit 3 is Effect Alt. (on/secondary = high)
Tweak 2
Crossover Frequency
Crossover Frequency
-
-
Resonance
Resonance
Resonance
Dry Level