Publicidad
Idiomas disponibles
Idiomas disponibles
d.
Press and release the 5 button
e.
Release the Enter button
f.
A confirmation tune will play
g.
If an entry is out of range or incorrect, a warning chirp will play
2.
To disable the Auto Relock timer, follow the steps above for #1 and enter 0 seconds to prevent the cart from auto relocking
3.
To turn ON the Auto Relock Warning beeper with custom length warning:
NOTE: The Auto Relock Warning will beep every 4 seconds for the time length specified prior to the cart automatically relocking.
a.
Access the cart with a supervisor credential (default supervisor code is 1350)
b.
Type in the number of seconds you want the Auto Relock Warning timer set for [valid range is 1 second to 999 seconds]
c.
Press and hold the Enter button
d.
Press and release the 8 button
e.
Release the Enter button
f.
A confirmation tune will play
g.
If an entry is out of range or incorrect, a warning chirp will play
4.
To turn OFF the Auto Relock Warning beeper:
a.
Access the cart with a supervisor credential (default supervisor code is 1350)
b.
Press and hold the Enter button
c.
Press and release the 7 button
d.
Release the Enter button
e.
A confirmation tune will play
5.
At any point when the cart is open, pressing any key (except LOCK/CLEAR) will reset the Auto Relock timer
NOTE: If the value entered for either the relock timer or the auto relock warning is more than the maximum set point, then the
maximum allowable value will be taken by default.
Section 6: SETUP Mode
SETUP MODE:
Set up Mode would be necessary only:
1.
In the event that initialization of the electronic lock was done via manual programming and it is now desired to add the electronic
lock to the database in LockView.
2.
In lieu of a valid Supervisor credential, set up mode allows manual programming of Supervisor and/or User credentials.
To place the electronic lock into SETUP mode:
1.
Press LOCK/CLEAR for 3 seconds.
2.
Enter the 8 digit setup code (Setup Cd) assigned to the electronic lock and press ENTER.(See green sticker set for setup code.)
NOTE: Each electronic lock has a unique setup code.
3.
Press LOCK/CLEAR to exit setup mode.
BASIC ELECTRONIC LOCK — MANUAL PROGRAMMING GUIDE
3
www.metro.com
L01-638
REV C 09/23
Publicidad
