Descargar Imprimir esta página

DRAGON WINCH DWM 10000 HD Manual Del Usuario página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

G) Load
Loads must be pulled in a straight line. If pulling loads at
an angle is necessary, use the appropriate load block. In
this case, the angle between the winch drum and the rope
should be 90 degrees.
H) Battery
The battery must be efficient, charged and of adequate
capacity [Ah].
Use rubber gloves and goggles when handling the battery.
When operating the winch, the vehicle engine should be
running.
WINCH OPERATING PRINCIPLES
leasing. Begin load winding with engaged gear. Do not
disengage and engage the gear while the winch motor is
running.
4. To avoid damaging the rope, do not install hooks directly
on the rope. It is necessary to use the factory-provided
thimble (eye) or pulley block with a movable pulley.
5. Observe the winch carefully during operation, while
maintaining the maximum possible distance. It is recom-
mended that the pulling process is stopped every meter to
check if the rope is wound correctly.
6. It is not recommended to attach the rope to the tow
hook of the pulled vehicle. The rope should be attached to
the vehicle frame.
www.dragonwinch.com
1. Remote control of the winch
should be stored in the vehicle.
2. Check the remote control tech-
nical condition before each con-
nection.
3. The winch is equipped with
a manual gear engaging and re-
GB
35

Publicidad

loading