cecotec BOLERO SQUAD V 2001 Manual De Instrucciones página 50

ENGLISH
5) Press the cooking-zone selection icon you wish to heat; the decimal point will be shown
on the display of the corresponding cooking zone.
6) Press the
7) Press the cooking-zone selection icon again and the corresponding cooking zone display
will show the single ring symbol. Then, press the cooking-zone selection icon again to
activate the double cooking ring; the display of the corresponding cooking zone will show
the double ring symbol. Finally, press the cooking-zone selection icon again and the
corresponding cooking zone display will show the triple ring symbol.
8) After setting the power level of the cooking zone and starting the heating of the inner
ring, only the inner ring will continue to operate when the cooking-zone selection icon is
pressed once. The inner ring and the double ring will work when pressed a second time.
The heating of the double and triple rings will start when the cooking-zone selection icon
is pressed for the third time and will stop when pressed a fourth time (the inner ring will
continue to operate).
4.3 Deactivation of the multi-ring cooking function
3) Press the desired cooking-zone selection icon; the decimal point will be shown on the
display of the corresponding cooking zone.
4) Then, press the cooking-zone selection icon again to activate the outer ring. The inner ring
will continue to function.
5. Setting the power level
- In standby mode, press the cooking-zone selection icon to select the desired cooking
zone. The decimal point will be shown on the display of the corresponding cooking zone
as well as the heating level. You can use the increase and decrease icons to adjust the
desired power level.
- You can quickly increase or decrease the power level by pressing and holding either icon.
Each time the
will be shown on the corresponding display. Each time you press the
level will be reduced by one, down to level 0 (each time you press the
you will hear a short beep).
- Once the power level adjustment is completed, the decimal point on the display will stop
flashing and will normally display the power level after 10 seconds of inactivity.
- When the power level of any cooking zone is changed to 0, that cooking zone will be
switched off.
- If one cooking zone has been heated, the power level of all cooking zones is "0". The
appliance will automatically switch off after 1 minute of inactivity.
6. Automatic heating function
6.1. Activate the automatic heating function: press the
level 9, then press the increase icon until the power level alternately displays "A" and "9".
Next, press the decrease icon to set the desired automatic heating level, e.g. level 6. In this
50
BOLERO SQUAD V 2001
/ icon to select the desired power level.
icon is pressed, the power level will increase by one, up to level 9, and
icon, the power
/ icons to set the power to
/ icons,