Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAFETY PRECAUTIONS
WARNING
• Installation must be performed according to the installation instructions. Improper installation can cause
water leakage, electrical shock or fi re.
• Use only the included accessories and parts and specifi ed tools for the installation. Using non-standard
parts can cause water leakage, electrical shock, fi re, injury or property damage.
• Make sure that the outlet is grounded and has the appropriate voltage. The power cord is equipped
with a three-prong grounding plug to protect against shock. Voltage information can be found on the
nameplate of the unit.
• The unit must be used in a properly grounded wall receptacle. If the wall receptacle is not adequately
grounded or protected by a time delay fuse or circuit breaker (the fuse of circuit breaker needed is
determined by the maximum current of the unit. The maximum current is indicated on the nameplate
located on the unit), have a qualifi ed electrician install the proper receptacle.
• Install the unit on a fl at, sturdy surface. Failure to do so could result in damage or excessive noise and
vibration.
• The unit must be kept free from obstruction to ensure proper function and to mitigate safety hazards.
• Do not modify the length of the power cord or use an extension cord to power the unit.
• Do not share a single outlet with other electrical appliances. Improper power supply can cause fi re or
electrical shock.
• Do not install the unit in a wet room such as a bathroom or laundry room. Too much exposure to water
can cause electrical components to short circuit.
• Do not install the unit in a location that may be exposed to combustible gas as this could cause fi re.
• The unit has wheels to facilitate moving. Make sure not to use the wheels on thick carpet or to roll over
objects as this could cause tipping.
• Do not operate a unit that been dropped or damaged.
• Do not touch the unit with wet or damp hands or when barefoot.
• If the air conditioner is knocked over during use, turn off the unit and unplug it from the main power
supply immediately. Visually inspect the unit to ensure there is no damage. If the unit has been
damaged contact a technician or customer service for assistance.
• In a thunderstorm, the power must be cut off to avoid damage to the machine due to lightning.
• The unit should be used in such a way that it is protected from moisture. e.g. condensation, splashed
water, etc. Do not place or store the unit where it can fall or be pulled into water or any other liquid.
Unplug immediately if this occurs.
• All wiring must be performed strictly in accordance with the wiring diagram location inside the unit.
• The units circuit board (PCB) is designed with a fuse to provide over current protection. The
specifi cations of the fuse are printed on the circuit board.
• When the water drainage function is not in use keep the upper and lower drain plugs fi rmly installed in
the unit. The drain plugs can be a choking hazard to children.
SAVE THESE INSTRUCTIONS!