Descargar Imprimir esta página

Midea MFD45S200W.2-ES Manual Del Usuario página 38

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
Before Calling For Service
Reviewing the charts on the following pages may save you from calling for service.
Problem
EN
Dishwasher doesn't
start
Water not pumped
form dishwasher
Foam in the tub
Stained tub interior
Possible reason
Fuse blown, or the
circuit break tripped.
Power supply is not
turned on.
Water pressure is low
Door of dishwasher
not properly closed.
Twisted or trapped
drain hose.
Filter clogged.
Kitchen sink clogged.
Wrong detergent.
Spilled rinse aid.
Detergent with
colourant
may have been used.
Solution
Replace fuse or reset circuit breaker.
Remove any other appliances sharing
the same circuit with the dishwasher.
Make sure the dishwasher is turned
on and the door is closed securely.
Make sure the power cord is
properly plugged into the wall socket.
Check that the water supply is
connected properly and the water
is turned on.
Make sure to close the door
properly and latch it.
Check the drain hose.
Check the filter system.
Check the kitchen sink to make sure
it is draining well. If the problem is
the kitchen sink that is not draining ,
you may need a plumber rather than
a serviceman for dishwashers.
Use only the special dishwasher
detergent to avoid suds. If this occurs,
open the dishwasher and let suds
evaporate. Add 1 liter of cold water
to the bottom of the dishwasher.
Close the dishwasher door, then select
any cycle. Initially, the dishwasher will
drain out the water. Open the door
after draining stage is complete and
check if the suds have disappeared.
Repeat if necessary.
Always wipe up rinse aid spills
immediately.
Make sure that the detergent has no
colourant.
35
EN

Publicidad

loading

Este manual también es adecuado para:

Mfd45s200x.2-es