Descargar Imprimir esta página

Kenmore ELITE 110.2403 Serie Manual De Uso Y Cuidado página 14

Ocultar thumbs Ver también para ELITE 110.2403 Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

When the Cycle Control knob is set to a number or cycle and
pulled out, the washer fills (to the selected load size) before
agitation and timing start. The washer begins agitating
immediately after filling; agitation occurs only with the washer lid
down.
During agitation, the agitator creates a continuous rollover action
that provides a thorough cleaning of the wash load.
After agitation starts, the Cycle Control knob turns until it points
to an OFF area and the cycle ends.
NOTE: The washer pauses briefly throughout
each cycle. These
pauses are normal for washer operation.
WASH
RINSE
1. Fill
_
1. Fill
,_
2. timeWaSh
selected
_
2. Rinse
3. Drain No
_j
3. Drain No
agitation
agitation
L_J
5. Spin
6. Off
Your new washer may make sounds your old one didn't. Because
the sounds might be unfamiliar, you may be concerned
about
them. These sounds are normal.
During washing
When you select a small load size setting, your washer has a
lower water level. This can cause a clicking sound from the upper
part of the agitator.
If you select CATALYST
TM
Cleaning Action, you will hear a spin/
spray noise at the start of the cycle.
During drain
If water is drained quickly from your washer (depending on your
installation), you may hear air being pulled through the pump
during the end of draining.
After drain and before spin
When the cycle changes from draining to spinning, you may hear
gears engaging.
LAUNDRY TIPS
Preparing clothes for washing
Follow these recommendations
to help you prolong the life of
your garments.
Close zippers, snaps, and hooks to avoid snagging other
items. Remove pins, buckles, and other hard objects to avoid
scratching
the washer interior. Remove non-washable
trim
and ornaments.
Empty pockets and turn them inside-out.
Turn down cuffs; brush away lint and dirt.
Turn synthetic
knits inside-out to avoid pilling.
Tie strings and sashes so they will not tangle.
Mend tears, loose hems, and seams.
Treat spots and stains.
Stained or wet garments should be washed promptly for best
results.
Sorting
Separate heavily soiled items from lightly soiled ones, even if
they would normally be washed together. Separate lint-givers
(towels, chenille) from lint-takers (corduroy, synthetics,
permanent press). When possible, turn lint-givers inside-out.
Separate dark colors from light colors, colorfast items from
noncolorfast
items.
Sort by fabric and construction
(sturdy cottons, knits, delicate
items).
Unloading
Remove clothes from washer after the cycle is completed.
Metal objects such as zippers, snaps, and buckles may rust if
left in the washer basket for a long time.
14

Publicidad

loading

Este manual también es adecuado para:

Elite 110.2404 serieElite 110.2405 serie