Publicidad
Idiomas disponibles
Idiomas disponibles
-
After heavily straining the power tool, continue
to run it at no-load for several minutes to cool
down the accessory.
-
Do not touch grinding and cutting discs before
they have cooled down. The discs can become
very hot while working.
TOOL
POWER SETTINGS
Mini Industrial Blade
Diamond Disc*
Grinding Disc*
Sanding Pad
MAINTENANCE
WARNING: BEFORE ANY
ADJUSTMENT, CLEANING OR
WORK ON THE MACHINE ITSELF,
DISCONNECT FROM THE POWER
SUPPLY.
CLEANING THE GRILLS AND SWITCH
Regularly check to see if any dust or foreign matter
has entered the grills positioned on the front and back
of the motor (fig. O and P) or under ON/OFF switch
(Fig. A).
If so use a soft brush to remove any accumulated dust.
to clean grills and switch.
TENSIONING OR REPLACING THE
BELT
Unplug the Mini Carver.
Remove the 4 bearing cap screws (10) (fig. R).
To remove guard cover, remove the cover screws (15)
then lift the back side and slide the cover back away
from blade and lift off(Fig.Q).
Rotate tensioning cap (Fig 18) to remove slack from
the belt (Fig S). The blade can be seen moving slightly
when rotating the Bearing Cap (9).
Ensure the belt is correctly positioned over the pulleys
as shown in Fig. S
When tensioning is finished align the Bearing Cap with
the nearest screw holes and tighten the screws. Then
secure the belt cover onto the arm.
APPLICATION
5-6
Wood carving
5-6
Grinding masonry material
5-6
Grinding metal
Sanding wood, metal and other
1-3
materials. Use lower speed for
higher grit sandpaper
DO NOT OVER TENSION THE BELT
Note: clean surroundings with a soft cloth or small
brush.
Accessories & spare parts
visit www.arbortechtools.com
English
6
Publicidad
