Casanoov BUNKER B500 Manual página 25

EN
Remote control
Button «1» pressed to operate a single door
Press «2» to operate a double door
Programming a new remote control :
> First step:
Press the LEARN button on the control panel [29] for about 1 second, the LED will go out.
Press any button on the new remote control for about 2 seconds, the digital display will show the remote
control number while the LED indicator on the control panel will start flashing four times with a BEEP.
Note! After pressing the LEARN button, if you do not receive the new remote control signal within 5
seconds, the LED indicator will light up and you will be taken out of pairing mode.
To remove the remote control :
Press and hold the LEARN button for approximately 5 seconds. If you hear a beep and the LED indicator
lights up, you have successfully removed the remote control.
Control panel settings
After power-up, the digital display checks itself from 00 to 99 with a BEEP. If the LED lights up and the
beep stops, the system is operating normally.
Basic operating mode :
Press and hold the [FUN] button until the digital display shows PO. This takes you to the menu setting.
You can adjust the [INC+] [DEC-] to increase or decrease the serial number or numerical value. Once the
data has been correctly set, press the [FUN] key to save the data. The beep indicates successful storage.
To move on to the next setting, press [INC+] or [DEC-] to select and confirm with [FUN] to enter the
menu number you want to set. For example, after saving the P0 value and pressing [FUN] to save it, the
digital display will still show the number P0, and if you want to go further to set P1, press [INC+], the
digital display will then show P1, then press [FUN] to enter the P1 setting.
When you have finished your settings, you can press the [LEARN] button to exit the menu setting.
25