Publicidad
Idiomas disponibles
Idiomas disponibles
shorten l ine to4-5inches ( 10-13
cm) a nduse atless than fullthrottle.
• For t rimming orscalping, use less
than fullthrottle t oincrease linelife
and decrease head wear, e specially:
• During l ight d uty cutting.
• Near o bjects a round w hich theline
canwrap such
as small posts,
trees or fence wire.
• For mowing or sweeping, use full
throttle for a good clean job.
TRIMMING
- Hold the bottom of the
trimmer head about 3 inches (8 cm)
above the ground and at an angle. Al-
low only the tip of the line to make
contact. Do not force trimmer line into
work area.
Trimming
3 in. (8 cm)
Above Ground
!
SCALPING
- The scalping technique
removes unwanted vegetation down
to the ground. Hold the bottom of the
trimmer head about 3 inches (8 cm)
above the ground and at an angle. Al-
low the tip of the line to strike the
ground around trees, posts, monu-
ments, etc. This technique increases
line wear.
Scalping
Mowing
SWEEPING
- The fanning action of
the rotating line can be used for a
quick and easy clean up. Keep the
line parallel to and above the surfaces
being swept and move the tool from
side to side.
Sweeping
EDGING - Adjust trimmer to the edg-
ing position (see TWIST AND EDGE
section).
Allow only the tip of the line
to make contact.
Do not force trimmer
line into work area.
Edging
MOWING - Your trimmer is ideal for
mowing in places conventional
lawn
mowers cannot reach. In the mowing
position, keep the line parallel to the
ground. Avoid pressing the head into
the ground as this can scalp the
ground and damage the tool.
8
Publicidad
