Publicidad
Idiomas disponibles
Idiomas disponibles
C. OUTSIDE BACK EXHAUST (HORIZONTAL DUCT)
INSTALLATION OVERVIEW
C1. Prepare Rear Wall
C2. Attach Mounting Plate to Wall
C3. Prepare Top Cabinet
C4. Adjust Blower
C5. Mount the Microwave Oven
REAR WALL TEMPLATE
C1. Preparing the rear wall for
outside back exhaust =
You need to cut an opening in the rear wall for
outside exhaust.
*
Read the instructions on the REAR WALL
TEMPLATE.
*
'Tape it to the rear wall.
*
Cut the opening, following the instructions of the
REAR WALL TEMPLATE.
C2. Attach the mounting plate to the
wall
18
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to a
wall stud.
1. Remove the toggle wings from the bolts.
2. Insert the bolts into the mounting plate through the
holes designated to go into drywall and reattach the
toggle wings to 34" onto each bolt.
To use toggle bolts:
Spacing for Toggles More Than
Wall Thickness
Toggle Wings
:
Toggle
w s
"
Ay
Bolt
m
y
y¥ dts.
-
N
t/
"oT Bolt End
Plate
wa
"eet
3. Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure to coincide bottom line of the
Mounting plate with Horizontal line of "Rear wall
Template" and then the Mounting plate is properly
centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and the wall.
4. Tighten all bolts. Pull the plate away from the wall to
help tighten the bolts.
Publicidad
