Descargar Imprimir esta página

Segway Ninebot eKickScooter E2 Pro Manual Del Producto página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
6
Recommended Maintenance Schedule
To ensure safe riding, day to day care and regular maintenance are essential. You, the owner, have control and knowledge of 
how often you use your scooter, how hard you use it and where you use it. It is the owner's responsibility to perform regular checks
and bring your scooter to authorized service center for inspection and service. Please refer to the maintenance schedule
below.
Note: This maintenance schedule charges a service fee.
Item
Component
Maintenance Method
Mainframe parts Use a soft, wet cloth to wipe the mainframe clean.
Inflate the tires to 50–55 psi.
Tire pressure
Tighten the six screws fixed with the handlebar and the
stem. The suggested torque is 5.5±0.3 N·m.
Tighten the screw on the throttle. The suggested
Mainframe
Screws on the
torque is 2.5±0.1 N·m.
maintenance
stem top
Tighten the screws on the brake levers. The suggested
torque is 5±0.1 N·m.
Tighten the screws on the stem top. The suggested
torque is 1.7±0.1 N·m.
To accelerate and decelerate, check if the hub motor is
Hub motor
stalled or has abnormal sounds.
Rear wheel
Check if the rear wheel is stalled or gets shaky, or the axis
shaft is unbalanced.
maintenance
Function
1) Spin the rear wheel, it spins normally. The rear wheel
Inspection
shall not stuck or make abnormal sounds.
Note: Slight noise does not affect riding safety. But if the
Drum Brake
drum brake makes loud noises when you apply brakes,
please contact customer service for support.
2) Squeeze the brake lever, the rear wheel stops moving.
07
Every 6
After 2 years or
months or
the total
Every 3
every 310
mileage > 3107
months
miles (500
miles (5000
km)
km)
Item
Component
Maintenance Method
Ambient light
Check the ambient light and see if it lights normally.
Headlight
Check the headlight and see if it lights brightly.
Toggle the direction indicator switch to the left/right
Direction
respectively, check if the direction indicators on the left/right
Indicators
side flash normally.
Dashboard
Power on the scooter, the dashboard works properly.
Press and hold the throttle, then release it, checking for
Throttle
acceleration and deceleration.
After connecting with the Segway-Ninebot app:
Function
1) Update the firmware to the latest version.
Inspection
Fault
2) Check if the notification of the corresponding error code and
detection
possible causes will prompt when the scooter detects an error.
Charge the scooter:
1) Check if the current battery power displays on the dashboard.
Charging
2) Check the LED indicator on the battery charger.
Charging: red, Fully charged: green.
Buttons
Press or toggle the button 3 times without failure.
Test with left turns and right turns (the steering angle is 60°).
Steering
No resistance or lag when turning.
The battery need to be replaced when it is charged and
discharged for 500 times or the total mileage is more than
Battery
9320 miles (15000 km).
assembly
Important
Note: It is recommended to charge once every 60 days for
parts
long-term storage.
Controller
It is required that original Segway-Ninebot parts shall be used
for repairs and replacements.
Hub motor
EN
Every 6
After 2 years or
months or
the total
Every 3
every 310
mileage > 3107
months
miles (500
miles (5000
km)
km)
08

Publicidad

loading

Este manual también es adecuado para:

051405u