Jacto GM-5 Manual Del Operador página 10

4.1. Assembly
Jacto GM-5 Ant Bait Applicator can be used with the 1-liter tank or the 18-liter tank
according to your needs. To assemble the tanks, follow the steps below:
• Insert the 1-liter tank and screw it as shown in the figures.
1)
2)
ATTENTION!
Do not over-tighten any parts.
• For use with the 18-liter tank, first, remove the tank lid as shown in the figures
below:
1)
• Run the hose through the clamp, fit it securely into the tank outlet, and tighten
the clamp:
1)
tank outlet
clamp
hose
• Insert the other end of the hose through the fairing and screw it back onto
the tank.
10/25
2)
2)
• Then, insert the adapter into the spreader and screw it.
OBS.: Before inserting the adapter, align the two screw holes as shown in the fig-
ure.
• Next, insert the hose through the clamp, fit it securely, and tighten the clamp.
1)
clamp
hose
4.2. Adjusting the strap
The equipment tank has an anatomical shape, providing greater comfort to the
operator. With a simple strap adjustment, the operator can position the equip-
ment correctly on his back.
• Pull the straps down to adjust them as needed.
A
pull strap
down
5. Operating the equipment
ATTENTION!
Do not operate your equipment if parts are missing.
Replace any defective parts before use. Misusing the
equipment can result in malfunction and personal injury.
ATTENTION!
When operating the spreader, wear personal protective
equipment (PPE), such as boots, gloves, protective
eyewear, and a face mask.
screw
adaptor
2)
B
strap lock