Publicidad
Idiomas disponibles
Idiomas disponibles
SETUP
GENERAL INFORMATION:
High Pressure
There are no serviceable parts to the high-pressure pump. Do not
Pump
attempt to repair or service the pump, as you may damage it and void
your warranty. If you feel that the pump needs service, please call our
customer service department at 1-855-888-3598.
Do not allow water to freeze in pump. If product is stored in an area
that will have temperatures of below 32° F, 0°C, make sure all water is
removed from the pump, or a suitable pump protection product has been
used. Failure to protect the pump form cold temperatures will cause
damage and possibly void your warranty.
By-pass
When you release the trigger of the gun, the pump goes into bypass
Mode
mode. It is good practice to never let the pump run in bypass mode for
more than 2 minutes. Damage to pump could be possible.
Thermal
Pump is equipped with a thermal relief valve. If during bypass mode the
Relief Valve
water overheats, this valve opens releasing the hot water and letting
new cool water enter the pump. Afterwards, the valve closes returning
pump to normal operation. Caution, the valve opens with no warning,
and the water will be hot. Possible injury can occur. Always keep hands
and feet away from thermal relief valve.
High Pressure
Do not allow hoses to come in contact with engine muffler during use or
Hose
immediately after use.
DO NOT attempt to move unit by pulling on high-pressure hose.
Engine
Do not adjust or attempt maintenance without reading owner's manual
or consulting our Customer Service at 1-855-888-3598. Add fuel
stabilizer (not supplied) to fuel tank and let engine run for 5 minutes
before storage. Always turn on water before starting engine.
Soap /
Use only soaps and chemicals detergents designed for pressure
Chemicals
washer use. Always follow detergent manufacturer's instructions on
their container. DO NOT use bleach, acid, any flammable materials, or
industrial solvents.
Nozzle
Always keep nozzles clean and unclogged. Use the nozzle needle
to clean if clogged. Use ONLY detergent nozzle (black) when using
chemical and cleaning solvents.
Storage /
Run clean water through chemical tank / inlet to clear any residual
Winterizing
detergent. Add stabilizer to any remaining fuel in fuel tank. See ENGINE
section above. Do not allow water to freeze in pressure pump, spray
gun, spray wand or hoses.
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
12
Publicidad
