Descargar Imprimir esta página

A-iPower PWF2700SH Manual Del Propietario E Instrucciones página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
Pre-Start Checks (Continued)
WARNING: Fire / Explosion Hazard
Fuel and fuel vapor are extremely flammable and explosive. Fire or explosion
from misuse of fuel can cause severe burns and even death.
• Fill the fuel tank in a well-ventilated area away from ignition sources. If the engine is
hot from use, shut the engine off and wait for it to cool before adding fuel.
• Do not smoke near open fuel tank or container.
• Failure to use fuel as recommended in this manual will void the warranty.
NOTICE: Do not use gasoline that has been stored in a dirty fuel container. It can cause
particles to enter the carburetor, affecting engine performance and / or causing damage.
Be sure the fuel tank strainer is clean and in place before adding fuel to tank.
2. Adding Fuel
2.1 Move the Pressure Washer OUTSIDE
of any building, or partially enclosed
structure, and place on a flat and level
surface.
2.2 Clean the Fuel Cap and the area
around it before removing.
2.3 Make sure Pressure Washer is OFF
and let it cool for at least two minutes
before removing fuel cap. Unscrew
slowly to release any built-up pressure
and remove the Fuel Cap.
2.4 Remove the Strainer and remove
any dirt and debris. Then replace the
Strainer.
NOTICE: When adding fuel to pressure washer, observe the following:
• DO NOT use unapproved gasoline such as E15 or E85 (15% ethanol, 85% ethanol).
• This is a four-cycle engine, DO NOT mix oil with gasoline.
DO NOT modify engine to run on alternate fuels. Any modifications to the engine will
void your warranty.
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
2.5
If needed, fill the Fuel Tank to about
1 inch under the fill neck of the
Fuel Tank with 87 octane or higher
unleaded gasoline that has been
treated with a fuel stabilizer additive.
Follow fuel stabilizer manufacturer's
recommendations for use.
2.6 Replace the Fuel Cap, making sure it
is tight ans sealed.
2.7 Wipe up any spilled fuel and allow
excess to evaporate before starting
engine. To prevent FIRE, do not start
the engine while the smell of fuel
hangs in the air.
14

Publicidad

loading