Publicidad
Idiomas disponibles
Idiomas disponibles
SETUP
7. Attach high pressure hose(D) to the
gun(A), pull back the quick-connect
collar(C) of hose and insert the spray
gun connector(B) and then release the
quick-connect collar(C). Once the hose
is connected, pull on the hose to make
sure it is firmly attached.
See Figure G.
8. Remove the protective cap on the Wand
inlet. Insert the Wand into the Spray Gun
See Figure H.
GENERAL INFORMATION:
Fuel
Use fresh high-quality unleaded gasoline (minimum 87 octane),
containing up to 10% ethanol.
Do not use fuel with high ethanol content; E15 or E85.
Oil
Engine oil: Use only SAE 1 0W-30, 0.6 Quart non-detergent oil
(supplied).
Pump Oil: The pump was lubricated and sealed at the factory, and is
maintenance free for the life of the product, under normal operation. Do
not attempt to change or add oil to the pump. If the pump is leaking oil,
please call our customer service department at 1-855-888-3598.
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
Figure G
A
B
C
D
Figure H
Wand
Spray Gun Tip
9. Attach the Nozzle to the Wand by
pulling back the quick connect collar
and pushing the Nozzle onto the end of
the Wand. Make sure the quick connect
collar locks the Nozzle in place.
See Figure I.
10. Connect the water supply hose to the
water inlet connection on the Pump and
See Figure J.
The water source must be able to
clean, cold water per minute at 20PSI.
Only use a 5/8" inner diameter, or larger
hose that is rated to meet this capacity.
11
Figure I
Nozzle
Quick Connect
Collar
Wand
Figure J
Publicidad
