Philips SRU 5150/87 Instrucciones De Manejo página 5

Manual_SRU5150_87
Notes:
– Batteries are already installed in the remote control.
– If you wish to set up the remote control for operating your TV, you can skip step 3.
– If your device is a Philips device, you can skip step 5.
– You can exit setup mode at any time by keeping SETUP pressed for three seconds.
– Once installed, a device cannot be deleted from the device list. Only the brand name can
be changed (e.g. if you wish to operate a device type of a different brand).
To delete a device you have to clear the entire memory. For this,
see 'Restoring the original functions of the remote control' under 4. 'Extra possibilities'.
1
Switch on the device you wish to set up the remote control for. If the device is a
DVD-player/recorder or video recorder, insert a disk or tape and start playback.
2
Pull out the protective strip from the battery
compartment to activate the batteries.
•
If the strip does not come out easily, open the battery
compartment to get better access to the strip.
– The remote control will immediately enter setup mode:
- the display shows '
- the backlight turns on;
- the keys that can be used are blinking.
– The remote control is now ready to be set up for operating your TV.
Use 4 to select the device you wish to set up
3
the remote control for (see table on previous page).
4
Confirm with OK.
– The display shows '
The keys that can be used are blinking.
Use 4 and 3 to select the brand of your device.
5
•
If the brand of your device is not on the list, you can select
any other brand.
6
Confirm with OK.
7
Keep y y pressed until the device responds.
– The display shows '
8
Point the remote control at the device.
– The remote control now starts emitting all known 'off
(standby)' codes, one by one. Each time a code is sent,
this is shown on the display: 'TEST 01, 0 2, 03', etc.
24-04-2007 15:47
', ' ' and 'TV?';
' and 'PHILIPS?'.
'.
Pagina 5
Instructions for use
5