Better Homes and Gardens Springwood BHS336158813020 Manual De Instrucciones página 4

Pre-attached
ready to assemble. To avoid causing damages to the thread, DO NOT over-tighten the nuts or screws.
1. Unpack the unit and confirm that you have all the hardware and required parts. Assemble the unit on a
carpeted floor or the empty carton to avoid any scratch.
2. Position one Seat (A) upside down on a level and protective surface.
3. Remove the plastic caps from the hanger bolts of the Legs (B and C) for the following steps.
4. Attach one Leg (B) to the left front corner of the Seat (A) by inserting the hanger bolts through the
drilled holes on the corner block.
5. Insert the tenon of one Side Stretcher (D) into the mortise of the Leg (B). Make sure that the slant holes
on the stretcher will face the floor when the unit is turned upright.
6. Repeat the same procedure to attach one Leg (C) to the left back corner block of the Seat (A). Ensure
the mortise on Leg (C) fits onto the tenon of the Side Stretcher (D) properly.
Assembly Instructions
A
DO NOT fully tighten the nuts or screws initially until all the nuts or screws are
Slant holes face upward
C
D
4
B