Worx WG102 Manual Del Usuario página 7

OPERATINGINSTRUCTION5
CONNECTING THE MAIN HANDLE AND
SHAFT (See A)
Turn the upper adjustment knob (3) clockwise
to loosen it.
Firmly insert telescopic shaft into the main
handle until it clicks into place (See A).
Retighten by turning counter-clockwise.
CONNECTING THE SAFETY GUARD
Slide the safety guard onto the trimmer head
by using the trimmer head grooves (See B).
Secure the safety guard by using the screw
provided, located inside of the guard.
CONNECTING THE SPACER GUARD
When not required, rotate the spacer guard
underneath the safety guard and clip into place.
ADJUSTING THE HEIGHT (See C)
Unscrew the lower adjustment knob (4) extend
the telescopic shaft, then retighten.
ROTATING THE MAiN N_DLE (See D)
Unscrew the upper adjustment knob (3),
rotate the main handle 90 degrees clockwise,
then retighten.
ADJUSTING THE AUXiLiARY HANDLE
Pull the handle release lever (5), rotate the
auxiliary handle to desired position, and
release.
OPERAT|ON
_ NARNiNG: Always wear eye protection
and heavy clothing to prevent rocks and
debris from hitting you and causing an eye
injury or other serious injuries. Use two hands
to operate the trimmer and hold the unit
below waist level. To best ensure that debris
is thrown away from your body, work only
from the right to left. For optimal trimming
and edging results while maintaining comfort,
keep the trimmer head parallel to the ground
when trimming (perpendicular, when edging).
When trimming be sure to keep sufficient
distance between the cutting line and the
ground.
_ ARN|NO: Before operating,
make sure both trimmer |ines are
extended. When trimming, make sure
motor is running at fuji speed.
WARN|NG: Use only 0.065" 1.65mm
diameter cutting line. Other line sizes
will not properly feed in the trimmer head and
could cause serious injury. Never use other
materials such as wires, string or rope, as this
may break off during cutting and cause serious
injury.
TRiMMiNG
Hold the bottom of the trimmer head about
3 in above the ground and at an angle. Allow
onlythe tip of lineto make contact. Do not
force trimmer line into work area.
ADJUSTING THE TRIMMER HEAD ANGLE
Grip the trimmer head with one hand and
the shaft with the other. Change the angle by
applying adequate force.You will hear a heavy
click for each angle adjustment, which is part
of the ratchet mechanism.The clicking sound is
normal and is not a defect ofthetool (See F).
ON/OFF TRIGGER
Press and hold the trigger to operate the
trimmer. Release to stop
_ ARN|NG: The cu_ing head
continues to rotate after the trimmer
has been switched off. Wait until it stops
before |aying the trimmer down.
EDGING (Bee G)
Unscrew the upper adjustment knob (3),
rotate the main and auxiliary handle 90 °, and
retighten the knob. Adjust trimmer head angle
so that it is in line with the shaft (horizontal).
Put the wheel on the ground to begin edging,
using the white line guides to indicate the
cutting position at the edge of your lawn.
While edging, allow the tip of the line to make
contact. Do not force the line.The wheel helps
prevent the unit from touching the ground.
Take extra caution while edging as objects can
be thrown from the trimmer line.
AUTOMATIC LiNE FEED SYSTEM
When initially switching on the trimmer, a
small length of line is fed out.