Worx WG780 Manual Del Usuario página 13

Please review t he following recommendations
foroptimum m ulching performance.
1) Avoid m owing when t he grass i swet f rom
rain ordew.Wet grass may form clumps
which i nterfere with the mulching action
and reduce runtime.
The best time tomow grass isinthe late
afternoon when t he grass i sdry and the
newly c ut a rea w illnot b eexposed to
direct sunlight.
2) For b est mulching performance, set
the cutting h eight toremove about one
third ofthe grass b lade l ength, ideally
nomore than 1-1/2" atonetime. Ifthe
lawn isovergrown, itmay benecessary
toincrease the cutheight toreduce the
pushing effort and prevent overloading
themotor. For e xtremely heavy mulching,
itisadvisable tofirst c utatahigh cut
height setting, and then re-cut tothe final
cutheight. Otherwise, make n arrower cuts
and mow slowly.
3) For b est performance, keep t he mower
housing free ofbuilt-up grass. From time
totime turn offmower and wait f orthe
blade t ocome t oacomplete stop.Then
unplug thesafety key and turn mower on
itsside. Using a nobject such a s astick,
wipe out a ny accumulation ofgrass i nthe
blade a rea. Be careful ofthe sharp e dges
ofthe blade. Clean often i nwet, n ew
grass, and always after e very use.
4) Certain types o fgrass orgrass conditions
may require that a narea bemulched a
second time tofullydisperse the grass
throughout thelawn.
ifcutting a second time, itisadvisable
tocutperpendicular (across) the first c ut
pattern. DO NOT C HANGE CUT PATTERN
IN ANY WAY
THATWOULD CAUSE MOWING DOWN A
HILL.
5) Change your c utting p attern from week t o
week.This willhelp prevent matting and
graining ofthe lawn.
MAINTENANCE
_tWARN|NG: Stop the and
mower remove
e safety key before removing the grass
bag.
NOTf:To ensure long and reliable service,
perform the following maintenance
procedures regularly. Check for obvious
defects such as a loose, dislodged or a
damaged blade, loose fittings, and worn
or damaged components. Check that the
covers and guards are all undamaged and
are correctly attached to mower. Carry out
any necessary maintenance or repairs before
operating mower. If the mower should
happen to fail despite regular maintenance,
please call our customer helpline for advice, 1-
866-354-9679.
B_Dl: SHARPI:NING
KEEP BLADE SHARP FOR BEST MOWER
PERFORMANCE. A DULL BLADE DOES NOT
CUT GRASS CLEANLY OR MULCH PROPERLY.
WEAR PROPER EYE PROTECTION WHILE
REMOVING, SHARPENING, AND INSTALLING
BLADE. ENSURETHAT SAFETY KEY IS
REMOVED.
Sharpening the blade twice during a mowing
season is usually sufficient under normal
circumstances. Sand causes the blade to dull
quickly, if your lawn has sandy soil, more
frequent sharpening may be required.
REPLACE BENT OR DAMAGED BLADE
IMMEDIATELY.
WHEN SHARPEMNG THE BIJ&DE:
1. Make sure blade remains balanced.
2. Sharpen blade at the original cutting
angle.
3. Sharpen cutting edges on both ends
of blade, removing equal amounts of
material from both ends.
TO SHARPEN IIH.ADE |N A V|Si: (SEB M)
1. Be sure the switch lever is released, the
blade has stopped and the safety key
removed before removing the blade.
2. Remove blade from mower. See
instructions for removing and attaching
blade.
3. Secure blade M-1 in a vise M-2.