Publicidad
Idiomas disponibles
Idiomas disponibles
Air quality sensor
The air quality sensor that controls the unit in automatic mode may be adjusted
to increase or decrease sensitivity. The sensor switch is accessible when the
front panel is removed. There are three settings: low, medium and high. Setting
the switch to HIGH will make the device more sensitive (reactive to a low
concentration of air contaminants). A setting of LOW reduces the sensitity so
that in automatic mode the KenkoAir Purifier
particle concentration is high.
It will take approximately 10-45 minutes for the KenkoAir Purifier™ to calibrate
during initial activation. The same 10-45 minutes is required for recalibration
when the unit is unplugged and replugged. Also, expect to see the air quality
sensor at "red" for an average of 10-35 minutes when any aerosol sprays are
detected (chemical, perfume, cleaners, etc.). If you turn the unit off and back on
(but do not unplug it), allow approximately five minutes for recalibration.
MAINTENANCE
CAUTION: When performing any maintenance operation, make sure the
KenkoAir Purifier
™
Never clean the unit by washing. Use a dry or damp cloth to wipe the exterior
only. Do not allow water to enter the unit.
Use a soft, dry or damp cloth to wipe the unit. Do not use solvents, chemical Use
Cleaning the exterior
Use a dry or damp cloth.
Cleaning the air outlet
Clean the air outlet (vent on outer surface) with a soft brush.
Cleaning the prefilter
Be sure to unplug the unit before cleaning.
The reusable prefilter should be cleaned every two months, or when the filter life
indicator on the control panel is flashing.
1.
Remove the front panel of the KenkoAir Purifier
Replacing Filters section. Detach the prefilter as described.
2.
Clean the prefilter by gently vacuuming or by immersion in warm water. If
the prefilter is very dirty, wash the surface with warm water mixed with a s
m all amount of dish soap.
3.
If washed, allow the prefilter to dry completely before replacing it in the
unit. Reinsert all filters and reattach the front panel.
is unplugged.
is activated only when the airborn
™
as described below in the
™
-8-
Publicidad
