Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
5. Battery
IMPORTANT: The battery is not charged when it
is purchased. Before using the trimmer for
and charge.
5a. To install:
a.
Align the battery (not included) with the cavity in
the string trimmer housing.
b.
Insert the battery into the handle until the battery
release button locks into place. Push down on the
battery until it locks into place. You should hear a
"click" once it is installed.
Note: The battery can only be installed one way.
5b. To remove:
a.
Press the battery release button on the string trimmer. This will cause the battery to raise out
of the tool slightly.
b.
Note:
WARNING: Follow these instructions in order to avoid injury and to reduce the risk of electric
•
Replace the battery immediately if the battery case is damaged.
•
Verify that the switch is in the OFF position before inserting or removing the battery.
•
Verify that the battery is removed and the switch is in the OFF position before inspecting,
adjusting, or performing maintenance on any part of the string trimmer.
6. Adjusting the cutter blade
This trimmer is equipped with a line cut-off blade on
the guard. The line cut off blade continuously trims
the line to ensure a consistent and efficient cut
diameter. Advance line whenever you hear the engine
running faster than normal, or when trimming efficiency
diminishes. This will maintain best performance and
keep line long enough to advance properly.
This trimmer is currently set at the 11 in. cutting swath.
To adjust to a cutting swath of 13 in.:
a. Remove the battery from the string trimmer.
b. Remove both screws on the cut-off blade with a
hex wrench.
c. Rotate the cut-off blade 180°.
d. Replace both screws in the cut-off blade.
Note: Set the cut-off blade to 11 in. for greater runtime.
Set the cut-off blade to 13 in. for greater cutting area.
5
Battery release button
of the handle.
order to prevent accidental dislodging.
6
13
Cut-off
blade
Publicidad
