Mounting informations
The drive will be full configured by factory.
The drives must be reconfigured in case of
alterations (e.g. removing of drives
from existing set or integrating
a new drive) with SCS.
At vertical active pulling application (e.g. for a
skylight) the forces must be rearranged by software
SCS
For option "IP 42": the chain outlet must not point
upwards.
8/20
KA-1-ACB
Mount the drives mechanical stress-free.
With that, a better load distribution
is ensured on all the drives.
If after mounting the measure x is as bigger as
23 mm, null balance with software SCS is neccesary.
Closure Ranges will shift in relation to new zero
point.
English
X
≥ 23 mm ?
99.829.14 1.0/07/23