Descargar Imprimir esta página

Craftsman EZ3 917.377571 Manual Del Propietário página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

PRODUCT
SPECIFICATIONS
MODEL
NUMBER
917,3775'71
_
NUMBER
DATE OF PURCHASE
HORSEPOWER:
63
DISPLACEMENT:
1256 CU° IN,
GASOLINE
CAPACITY/TYPE:
1,25 QUARTS
UNLEADED
REGULAR
OIL TYPE (APl-SF/SG/SH):
SAE 30 (ABOVE 32°F)
SAE 5W-30 (BELOW
32°F)
OIL CAPACITY:
20 OZS,
SPARK PLUG(GAP:
.030")
CHAMPION
RJ19LM
OR J 19LM
VALVE CLEARANCE:
INTAKE:
,004" - .008"
EXHAUST:
.004" - .008"
SOLID STATE IGNITION
AIR GAP:
.0125 IN,
BLADE BOLT TORQUE:
35-40 FT. LBS.
The model and serial numbers will be found on a decal attached to the rear of the
lawn mower housing,Record
both serial number and date of purchase
in space
provided
above,
LAWN MOWER
Always observe safety rules when performing
any maintenance,
TIRES
. Keep tires free of gasoline, oil, or insect
control chemicals which can harm rubber.
° Avoid stumps, stones, deep ruts, sharp
objects and other hazards that may cause
tire damage.
BLADE CARE
For best results, mower blade must be kept
sharp.
Replace bent or damaged blades.
TO REMOVE BLADE
• Disconnect spark plug wire from spark plug
and place wire where itcannot come in
contact with spark plug.
• Turn lawn mower on its stde. Makesure air
filter and carburetor are up.
, Use a wood block between blade and
mower housing to prevent blade from
turning when removing blade bolt.
° Protect your hands with gloves and!or wrap
blade with heavy cloth.
= Remove blade bolt by turning counter-
clockwise. Use a 9/16" box or open-end
wrench.
• Remove blade and attaching hardware
(bolt, lock washer and hardened washer),
NOTE:
Remove the blade adopter and
check the key inside hub of blade adapter.
The key must be in good condition to work
properly_ Replace adapter if damaged.
TO REPLACE BLADE
• Position the b{ade adapter on the engine
crankshaft, Be sure key in adapter and
crankshaft keyway are aligned,
• Position blade on the blade adapter aligning
the two (2) holes in the blade with the raised
lugs on the adapter.
• Be sure the trailing edge of blade (opposile
sharp edge) is up toward the engine.
• Install the blade bolt with the tock washer
and hardened washer into blade adapter
and crankshaft.
° Use blockof wood between blade and lawn
mower housing and tighten the blade bolt,
turning ctockwise_
• The recommended tightening torque is 35-
40 ft. Ibs,
IMPORTANT:
Blade bolt is grade 8 heat
treated,
11

Publicidad

loading