Publicidad
4-Ch. Amp. - High Power 2-Ch. Mode
Similar to bridging a stereo amp to a mono woofer, you can use the 4-Ch amp in a dual mono mode
to create a high power stereo amp. As with any bridged setup the speakers must be a minimum
of 4Ω impedance. If you are using the active crossovers you should be sure that they are set to the
same frequency.
BRIDGED 4 OHM MIN
BRIDGED 4 OHM MIN
12
4-Ch. Amplifier - 5-Ch. Mode
A 3-way system with front stage, rear stage and sub. in mixed mono configuration.
The 5-speakers system requires a passive crossover between the front highs and the mono woofer,
with capacitors on the front highs positives and a coil on the woofer positive. All amplifiers
channels are full range.
X-OVER
X-OVER
2 OHM MIN/CH
X-OVER
4 OHM
MIN LOAD
X-OVER
2 OHM MIN/CH
13
Publicidad
