Publicidad
Idiomas disponibles
Idiomas disponibles
TO USE CRUISE
CONTROL
The cruise control feature
can be used for
forward
travel only.
SYSTEM
CHARACTERISTICS
The cruise control should
only be used
while mowing
or transporting
on relatively
smooth,
straight surfaces.
Other conditions
such as trimming
at slow speeds
may
cause the cruise control to disengage.
Do
not use the cruise control on slopes,
rough
terrian
or while trimmimg
or turning.
• With forward
drive pedal (K) depressed
to desired
speed, pull cruise control
lever (J) up and hold while lifting your
foot off the pedal, then release the lever.
To disengage
the cruise control,
depress
the brake pedal or tap on forward
drive
pedal.
TO ADJUST
MOWER
CUTTING
HEIGHT
The position
of the attachment
lift lever (A)
determines
the cutting height.
TO ADJUST
GAUGE
WHEELS
Gauge wheels
are properly
adjusted
when they are slightly
off the ground when
mower is at the desired
cutting
height
in
operating
position.
Gauge wheels
then
keep the deck in proper position to help
prevent
scalping
in most terrain
conditions,
NOTE:
Adjust gauge wheels
with tractor
on a flat level surface.
I,
Adjust
mower to desired
cutting
height
(See "TO ADJUST
MOWER
CUTTING
HEIGHT"
in this section
of manual).
2. With mower in desired
height of cut
position,
gauge wheels
should
be
assembled
so they are slightly
off the
ground.
Install gauge wheel
in appro-
priate hole. Tighten
securely.
3.
Repeat for all, installing
gauge wheel in
same adjustment
hole.
9}16
- Put attachment
lift lever in desired
cutting
height slot.
The cutting
height
range is approximately
1" to
4". The heights
are measured
from
the ground
to the blade tip with the engine
not running.
These heights are approximate
and may vary depending
upon soil condi-
tions,
height
of grass and types
of grass
being mowed.
• The average
lawn should
be cut to ap-
proximately
2-1/2 inches during the cool
season
and to over 3 inches
during
hot
months.
For healthier
and better looking
lawns,
mow
often
and
after
moderate
growth.
, For best cutting performance,
grass over
6 inches
in height
should
be mowed
twice.
Make the first cut relatively
high;
the second
to desired
height.
TO OPERATE
MOWER
Your tractor
is equipped
with an operator
presence
sensing
switch.
Any attempt
by the operator
to leave the seat with the
engine
running and the attachment
clutch
engaged
will shut off the engine.
You must
remain fully and centrally
positioned
in the
seat to prevent the engine from hesitating
or cutting
off when operating
your equip-
ment on rough,
rolling terrain
or hills.
1. Select desired
height of cut with at-
tachment
lift lever.
2.
Start mower blades
by engaging
at-
tachment
clutch control.
12
Publicidad
