Descargar Imprimir esta página

cecotec CONGA HAND CARPET&SPOT CLEAN 1500 Manual De Instrucciones página 54

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 4
ENGLISH
water continuously. Stop pressing the button for the appliance to stop spraying water.
4. To turn the vacuum cleaner off, press the power button again.
When the vacuum cleaner is charging, the corresponding green indicator light will light up
and flash successively. Once the device is fully charged, these three indicator lights will
remain on without flashing, and will turn off after 30 minutes.
Warning
-
Do not tilt, tip, or use the appliance upside down or in an upright position when there is
water in the tank; otherwise, the water may overflow from the air outlet.
-
When using the vacuum cleaner slightly tilted downwards, prevent the dirty water from
exceeding the water level mark indicated on the tank and empty the drained excess
water; otherwise, it may overflow from the air outlet.
-
In case of use with suction function only, you can use it with an empty water tank. In this
case, do not press the spray button to prevent air from entering the water pump.
4. CLEANING AND MAINTENANCE
Turn off the vacuum cleaner before cleaning or performing any maintenance.
Cleaning the waste-water tank
The waste-water tank must be emptied before it reaches its maximum capacity.
1.
Leave the vacuum cleaner in an upright position for 10 seconds to allow any water
remaining in the nozzle to flow into the waste-water tank.
2. Remove the water tank from the vacuum cleaner body and open the waste-water outlet
cover of the tank to empty it. To remove the water tank, press the tab, and pull the tank
until it separates completely from the body of the vacuum cleaner.
3. Empty the waste-water tank by opening the cap and tipping out the tank.
Attention
Make sure not to confuse the clean water tank with the waste-water tank and vice versa.
Cleaning the suction cover
-
In case you need to clean the inside of the suction cover, press the tabs on both sides of
the cover and pull it downwards as indicated by the arrow. Fig. 4.
-
After cleaning, install the cover back in place.
Attention
Clean the nozzle regularly to prevent the air duct from clogging.
Exterior cleaning
-
Wipe the exterior with a soft, slightly damp cloth.
54
CONGA HAND CARPET&SPOT CLEAN 1500

Publicidad

loading

Este manual también es adecuado para:

08143