Operation Of Wireless Remote Control - Daitsu DS-18UIAK Manual De Usuario

Operation of wireless remote control

Note: Besure that there are no obstructions between receiver and remote controller;
Don't drop or throw the remote control; Don't let any liquid in the remote control and
put the remote control directly under the sunlight or any place where is very hot.
Signal transmitter
Remote control
ON/OFF
ON/OFF button
● Press this button, the unit will be turned on,
press it once more, the unit will be turned off.
When turning on or turning off the unit, the
Timer, Sleep function will be canceled, but the
presetting time is still remained.
MODE
MODE button
●Press this button, Auto, Cool, Dry, Fan,
Heat mode can be selected circularly.
Auto mode is default while power on.
Under Auto mode, the temperature will not
be displayed; Under Heat mode, the initial
value is 28 ºC (82ºF); Under other modes,
the initial value is 25 ºC (77 ºF).
AUTO
COOL
HEAT
(Only for cooling and heating unit.
As for cooling only unit, it won't have
any action when it receives the signal
of heating operation.)
Name and function of wireless remote control
DRY
FAN
SLEEP
SLEEP button
●Press this button, Sleep On and Sleep
Off can be selected. After powered on,
Sleep Off is defaulted. After the unit is
turned off, the Sleep function is canceled.
After Sleep function set up, the signal of
Sleep will display. In this mode, the time of
timer can be adjusted. Under Fan and Auto
modes, this function is not available.
FAN
FAN button
● Press this button, Auto, Low, Middle,
High speed can be circularly selected.
After powered on, Auto fan speed is
default. Under DRY mode, Low fan speed
only can be set up.
Low fan
High fan
CLOCK
CLOCK button
● Press this button, the clock can be set
up, signal
seconds, the value can be adjusted by
pressing + or - button, if continuously
press this button for 2 seconds above, in
every 0.5 seconds, the value on ten place of
Minute will be increased 1. During blinking,
repress the Clock button, signal
be constantly displayed and it denotes the
setting succeeded. After powered on, 12:00
is defaulted to display and signal
displayed. If there is signal
thet denotes the current time value is Clock
value, otherwise is Timer value.
7
Middle fan
blink and display. Within 5
will be
be displayed
will