Profi Care PC-GKH 3119 Manual De Instrucciones página 16

5. Now mount the other two mounting brackets on the underside of
the appliance as illustrated.
These mounting brackets serve as spacers.
6. Hold the appliance by the sides and hang it on the mounting
brackets. Note the suspension openings on the back of the appli-
ance. Slide the appliance into the slots of the mounting brackets.
Remote Control
The lithium cell in the battery compartment
of the remote control has been secured with
a plastic film for transport. This prolongs the
life of the battery. Before using the remote
control for the first time, the plastic film must be removed so
that it is ready for use.
When operating, make sure that there is a clear view be-
tween the remote control and the sensor under the display
of the appliance. When the range of the remote control de-
creases, the battery must be changed. To change the bat-
tery, proceed as follows:
1. Press the lock in the direction of the
arrow (1).
2. Pull the holder for the button cell out of
the remote control (2).
3. Replace the cell with a battery of the
same type (CR 2025). Make sure that
the polarity is correct.
4. Push the holder back into the battery compartment until
it clicks into place.
16
PC-GKH3119_IM
Electric Connection
1. Make sure the voltage of the appliance (see rating label)
matches the mains voltage to be used.
2. Connect the mains plug with a properly installed earthed
socket. A signal tone sounds. The current ambient tem-
perature is then displayed.
Notes for Use
• The appliance is equipped with overheating protection.
When the ambient temperature reaches 51 °C, the
appliance switches off.
• Avoid opening doors and windows during heating opera-
tion, as this will impair the heating effect.
• The current ambient temperature is displayed.
• Settings can only be made during operation.
• Some buttons are located both on the appliance and on
the remote control. The same buttons have the same
function.
• The buttons on the appliance are sensor buttons. Touch
the buttons lightly with a finger to perform the function.
• Each key press is confirmed by an acknowledgement
tone.
• The display dims after 30 seconds if no button is
pressed.
01.09.23