Publicidad
Idiomas disponibles
Idiomas disponibles
4. ASSEMBLY
Remove the electric wheelchair from the packaging, unfold the wheelchair by pulling the backrest outwards, then lift the backrest using the
handles at the back of the backrest until the locking mechanism engages. Unfold the frame of the wheelchair towards the outside and
press down on both sides of the seat until it is completely unfolded. To fit the upper part of the backrest, place the two tubes in place on
either side of the seat base. (see fig. 1, 2 ).
2 Put the cushions on the seat and backrest (see fig. 3).
3. loosen the screws located at the control panel bracket and position it at the armrest . Then install the control unit by tightening the
screws (see fig. 4). It is possible to mount the control unit on both the right and left sides.
Connect the control unit's cable plugs of corresponding description to the battery, fix the cables to the frame with plastic cable ties (see
Fig. 5 and 6). .
5 Fit the footrests to the tubes on the left and right sides of the frame (see fig. 7). Turn the footrests forward to lock them in the extended
position, fit the anti-tip wheels (see Figures 7 and 8).
6. fix the straps with nylon tape (see fig. 9).
7. adjust the height of the footrest, unscrew the locknuts on both sides of the footrest, remove the bolts (see fig. 10), move up or down the
component on which the footrest is fixed, adjust to the correct height, then insert the bolts and tighten the nuts.
5. OPERATION
Control panel
The control panel is a key component of the power wheelchair. The panel contains all the electric elements to operate the wheelchair (see
Fig. 11). The control panel is located on one of the armrests and is connected to the batteries along with the motors.
The control panel consists of the following parts:
1. Joystick
2. Battery indicator
3. On/off button
4. Speed indicator
5. Acceleration button
6. Release button
7. Horn
8. Charger socket
Ul_AT52313
Publicidad
