Antar AT52313 Manual De Usuario página 12

6. Precautions
Make sure the control panel is properly installed and the joystick is in the center vertical position.
In order to prevent any damage to health, after sitting down, fasten the seat belts, rest your body on the backrest and raise your head.
After switching on the wheelchair, first check that the maximum speed indicated by the speed indicator on the control panel is suitable for
the user. If not, adjust it using the acceleration or deceleration button on the control panel. To be on the safe side, we recommend using a
slower speed and then adjusting it by increasing it step by step.
If the wheelchair moves voluntarily, release the joystick immediately, which will stop the wheelchair if the joystick is functional.
Warning: Keep your feet on the footrest only;
Warning: Do not extend your arms beyond the armrests while driving.
Warning: Before using the wheelchair, make sure it is locked with the brakes.
7. Folding/unfolding and storing the wheelchair
The wheelchair must be folded for transport and storage as follows:
1. place the wheelchair on the ground. Disconnect the power supply.
2. lift the footrest and rotate outwards by 90° (see figure 18).
3. tilt the footrest frame section outwards, rotate 90° and pull (see figure 19).
4. press the backrest folding lock on both sides of the handle (see figure 20).
Fold the backrest and frame of the pram by lifting upwards by the centre of the seat (see figure 21).
18
20
8. Charging the battery
The battery can be quickly and easily recharged using the separately supplied electric wheelchair charger.
ATTENTION! The wheelchair battery should only be charged with the supplied charger. Do not use other battery chargers, such as car
chargers.
Charge the battery with the separately supplied charger:
- Make sure that the control panel is turned off and that the brake lever is applied.
- Connect the three-pole plug to the three-pole socket on the control panel (see figure 22).
- Connect the charger plug to the power socket.
- Charging is signaled by the LED turning red. When the battery is fully charged, the LED turns green.
- The recommended charging time is 8-12 hours.
- When charging is complete, disconnect the charger plug from the electrical outlet and then disconnect it from the plug on the control
panel. Keep the charger, cables and plugs together in the pocket behind the backrest.
9. Overload protection
When the motors are overloaded, the overload protection will cut off the current to protect the motors and their electrical parts. The
overload protection must be set by qualified specialists: unscrew the screws on the battery box, replace the backup fuse with a broken one,
replace the battery box cover, tighten the screws.
Ul_AT52313
19
21