Tool Assembly - Milwaukee 48-05-1000 Manual Del Operador

WARNING!
To reduce the risk of injury,
always unplug tool before attaching
or removing accessories or making
adjustments. Use only specifically
recommended
Others may be hazardous.
Magazine Attachment
(Cat. No. 48-05-1000)
1. Snap bit (4) and bit holder (5) into tool.
2. Snap magazine (1) onto tool. Notches
on adapter must match up with projec-
tions on tool (Fig. 1).
Fig. 1
Notches
Projections
3. Attach belt guide (7) to handle (6) with
belt guide screw (8).

TOOL ASSEMBLY

accessories.
Magazine Attachment
(Cat. No. 48-05-1005)
1. Snap bit (5) and extension drive shaft
(6) onto tool.
2. Slide side handle (7) over extension
tube (4).
3. Slide the extension tube (4) over the
drive shaft (6). Notches on extension
tube must match up with projections on
tool (Fig. 1). Tighten set screws (8) se-
curely.
4. Slide side handle (7) back toward tool.
Tighten securely.
5. Remove the shoulder screw (17). Slide
the magazine (1) onto the extension
tube (4). Replace and tighten shoulder
screw (17) securely.
6. Attach belt guide (11) to magazine (1)
with belt guide screw (12).
7. Fit belt guide clamp (9) around exten-
sion tube (4) with the slotted guide
screw (10) facing toward magazine (1).
Slide belt guide clamp (9) forward until
slotted guide screw (10) is inserted into
belt guide (11). Tighten belt guide clamp
(9) securely.
Changing Bits
1. Remove shoulder screw.
2. Pull magazine off tool.
3. Turn the ring on the bit holder or exten-
sion drive shaft until the red alignment
dot appears (Fig. 2).
Fig. 2
Ring
4. Remove or insert a bit.
5. Turn the ring to secure.
6. Replace magazine.
7. Replace and tighten shoulder screw
securely.
5
Red
alignment
dot