Publicidad
Idiomas disponibles
Idiomas disponibles
Saw
Operations
Crown Molding Angled to Table and Fence
The preferred method for cutting crown molding with
this saw is with the molding laying flat on the table.
• The advantage to cutting moldings angled against
fence is that no bevel setting is required. Only the
miter angle is adjusted.
• The maximum crown molding width that can be
cut and angled to table and fence is 6".
• When cutting crown molding in this fashion it is
recommended
to purchase and use the optional
MS 1221 Horizontal
Clamp and Crown Molding
Stop Accessory.
Follow these instructions
for cutting
crown molding
angled to table and fence.
1. Position the molding so the bottom (decorative
part, which is installed against the wall) is against
the fence.
2. For 90 -0corner, set the miter angle using Chart
below. Tighten the miter lock knob (Figure 36).
3. Support
crown molding against the fence (see
"Body and Hand Position" on page 19.)
4. Follow the procedures for chop or slide cut (see
page 23).
5. Wait until blade comes to a complete stop before
returning
head assembly
to the raised position
and/or removing workpiece.
NOTE: ALWAYS
TAKE
A TEST
CUT
SCRAP TO CONFIRM CORRECT ANGLES.
Crown Molding
Angled Against Fence
--45_Miter
Figure 36. Crown Molding Angled to
Table and Fence
USING
Miter and Bevel Settings
for Standard
Crown Molding
Cuts
(When Workpiece Angled Against Fence)
Assumptions:
Molding is milled consistently.
•
Corner is 90 degrees.
• For other corner angles, divide actual measure-
ment by 2.
For any Crown Molding
Miter
Bevel
(Table)
(Tilt)
Setting
Setting
Inside Corner
Left end (A)
Use the right end of the cut
Right end (B)
Use the left end of the cut
(45) Right
0 Left
(45) Left
0 Right
Outside
Corner
Left end (C)
Use the right end of the cut
Right end (D)
Use the left end of the cut
(45) Left
0 Right
(45) Right
0 Left
30.
Publicidad
