Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Choosing the location
In order to ensure that heat dissipates
rapidly and that the refrigerator operates
efficiently, with low energy consumption,
we recommend leaving the following
minimum distances between the
refrigerator and the walls and ceiling:
Top: 30cm
Sides: 20cm
Door side: 30cm
Back: 10cm
Check to be sure that there is enough
space in front of the refrigerator to open
the door (160°).
Install the refrigerator in a well-ventilated
area, away from direct sunlight and from
heat sources, such as ovens and burners,
from inflammable materials, and from
areas where water is frequently used, such
as sinks.
Do not install the refrigerator outdoors.
Leveling the refrigerator
Install the refrigerator on a completely
level and solid surface. The door must
be closed when leveling the refrigerator
Use a level with glass-enclosed bubble
to verify whether the refrigerator is
properly leveled, with the four feet firmly
on the floor.
If the refrigerator needs to be adjusted,
carefully lean it and turn the front
adjustable leveling feet until it is firmly
installed.
Proper leveling prevents movement,
vibration and other problems.
Do not substitute the original refrigerator
feet.
Wait at least 2 hours before plugging the
refrigerator in this will prevent operating
problems.
29
30cm
(top)
10cm
(back)
20cm
(side)
30cm
(door side)
Electrical installation
Before turning on the refrigerator, check
to see if the voltage of the outlet to be
used is the same as that indicated on
the tag located close to the plug (along
the power cord) or on the refrigerator's
identification label.
Check to see that the refrigerator's plug
is not connected on top of the power
cord.
Connect the refrigerator to its own
outlet. Do not use an extension cord or
adaptor plug.
For your safety, ask an electrician to
verify the condition of the electric wiring
in the area where the refrigerator will be
installed.
The wires leading to the outlet into
which the refrigerator will be plugged
should be made of copper and be at
least 2.5 mm2 wide. For greater safety,
consult the legislation on electrical
installations in your country.
Grounding
The power cord has a three-pronged
grounded plug for your personal safety.
It must be connected to a grounding
type wall receptacle, in accordance with
the legislation governing electric
installations in your country, as well as
any local regulations. Do not remove the
grounding prong, do not use a two
pronged adaptor, and never make a
connection to the schematic. Use the
cord supplied with the equipment (do
not change it). If the cord is damaged, it
must be immediately replaced by
specialized personnel.
Attention
For your safety, installation must be
grounded. If it is not grounded, it
must be adapted for this by
specialized personnel.
30
Publicidad
