Joie i-Jemini Manual De Instrucciones página 6

!
Make sure that both ISOFIX connectors are securely attached to the
vehicle's ISOFIX anchor points. There should be two audible clicks
and the colors of the indicators on both ISOFIX connectors should
be completely green. -1
4
!
Check to make sure the base is securely installed by pulling on both
ISOFIX connectors.
5. After placing the base on the vehicle seat, extend the load leg to
floor 5 . When the load leg is installed correctly, the load leg
indicator will show green. Red will be shown when installed
incorrectly. 5 -2
The load leg has multiple positions. When the load leg indicator
shows red this means the load leg is in the wrong position.
!
Make sure the load leg is in full contact with the vehicle floor pan.
!
Squeeze the load leg adjustment button, then shorten the load leg
upwards. -1
5
!
Always make sure the support load leg has direct contact with the
floor and is in locked position even when the child is not in it.
6. The completely assembled base is shown as
!
The ISOFIX connectors must be attached and locked onto the
6
ISOFIX anchor points. -1
!
The load leg must be installed correctly with green indicator.
!
Please install the enhanced child restraint on the rear vehicle seat
and then put the child in the enhanced child restraint.
7. Push the enhanced child restraint down onto the base
enhanced child restraint is secure, the enhanced child restraint
8
indicator will show green.
!
The enhanced child restraint can ONLY be installed and released
when in rearward facing mode.
8. Press the rotating button to rotate for easier side loading/unloading
of the child. 9
5
6
5
-2
. If the
7
!
Rotate the enhanced child restraint to the rear facing position. The
enhanced child restraint indicator will show green.
9. To release the enhanced child restraint, first take the child out of the
child restraint. Pull the child restraint release button
the child restraint up -2.
11
10. To remove the base from the vehicle seat, push the secondary lock
buttons -1 first and then press the ISOFIX releasing buttons
12
on the ISOFIX connectors before removing the base from the vehicle
seat.
12
11.For transporting, press ISOFIX adjustment button and move the
ISOFIX connectors back into the storage position.
10
-1, then lift
11
-2
12
13
6