Publicidad
Idiomas disponibles
Idiomas disponibles
The operation ofanylawn
mower conresult inforeign
objects thrown i ntothe
eyes, which
con result in
severe eye damage.
Always wear safety glasses or eye
shields while operating your lawn mower
or performing any adjustments or repairs.
We recommend a wide vision safety
mask over spectacles or standard safety
glasses.
HOWTO USEYOUR
LAWN MOWER
ENGINE SPEED
The engine speed was set at the factory
for optimum performance. Speed is not
adjustable.
ENGINE ZONE CONTROL
_,CAUTION:
Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the risk
of blade contact injury. Do not under any
circumstances attempt to defeat the
function of the operator control.The blade
turns when the engine is running.
• Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
DRIVE CONTROL
• Self-propelling is controlled by holding
the operator presence control her down
to the handle and pushing the drive
control lever forward until it clicks; then
releasing the lever.
• Forward motion will stop when the
operator presence control bar is
released. To stop forward motion
without stopping engine, release the
operator presence control bar slightly
until the ddve control disengages. Hold
operator presence control bar down
against handle to continue mowing
without self-propelling.
• To keep drive control engaged when
turning comers, push down on handle
end lift front wheels off ground while
turning lawn mower.
Operatorpresencecontrolbar
Ddve
control
TO ADJUST CU'rFING HEIGHT
Raise wheels for low cut and lower
wheels for high cut, adjust cutting height
to suit your requirements. Medium
position is best for most lawns.
To change cutting height, squeeze
adjuster lever toward wheel. Move
wheel up or down to suit your require-
ments. Be sure ell wheels are in the
same setting.
NOTE: Adjuster is propedy positioned
when plate tab inserts into hole in lever.
Also, 9-posiiton adjusters (if so equipped)
allow laver to be positioned between the
plate tabs.
LowerWheelsfor HighCut
r_e
Tab_
RaiseWheelsfor Low Cut
Lever
TO CONVERT MOWER
Yourlawn mowerwas shippedreadyto be
ussd as a mulcher.To convertto hegging :
REAR BAGGING
• Liftrear door ofthe iswn mower and place
the grasscatcherframe hooksontothe
door pivotpk_.s.
• To conve_ to mulchingopera,on, remove
grassc_cher and dose rear door.
ACAUTION:
Do not run your lawn mower
without clipping deflector or approved
grass catcher in place. Never attempt to
operate the lawn mower with the rear
door removed or propped open.
pivot "
Rear
Grass
catcher
_.
handle
-\
Catcherframe
To engage
Drive control
drive control
disengaged
7
Publicidad
