Oase Eco Control Instrucciones De Uso página 12

Installation and connection
Fastening the device to the pump
How to proceed:
 B
1. Fit the holding clip onto the pump handle.
2. Slide the device onto the holding clip.
3. Align the device.
Installing the device with the ground stake
How to proceed:
 C
1. Fully insert the ground stake into the ground.
2. Slide the device onto the ground stake.
3. Check its stability.
Fastening the device to the wall
How to proceed:
 D
1. Remove the retaining frame and fasten it to the wall using suitable screws.
2. Fit the device into the retaining frame.
– Ensure that the device is properly engaged in the retaining frame.
Connect the unit
NOTE
The unit will be damaged, if water enters the plug connector.
 Connect the plug connector or place the protective cap on it.
Ensure that the rubber seal is clean and fits exactly.

 If the rubber seal is damaged, it must be replaced. When the plug connector is disconnected,
the rubber seal must be replaced if it is older than 2 years.
 Always secure the plug connector or the protective cap with the two screws.
How to proceed:
 E
1. Remove the protection cap from the unit.
2. Fit the plug connector and secure with the two screws (max. 2.0 Nm (max. 18 lb-in)).
– Ensure that the rubber seal is clean and fits exactly.
– Replace the rubber seal if damaged.
– Only connect the plug to the left-hand EGC socket.
12