Publicidad
Idiomas disponibles
Idiomas disponibles
Important Placement Guidelines
a.
To ensure accurate temperature measurement, place units out of direct sunlight and away from any heat sources
orvents.
b.
Display unit and outdoor sensor must be within 99ft (30m) of each other.
c.
To maximize wireless range, place units away from large metallic items, thick walls, metal surfaces, or other
objects that may limit wireless communication.
d.
To prevent wireless interference, place both units at least 3ft (1 m) away from electronic devices (TV, computer,
microwave, radio, etc.
OUTDOOR SENSOR PLACEMENT
a.
The sensor must be placed outside to observe outdoor conditions. It is water resistant and designed for general
outdoor use, however, to prevent damage place the sensor in an area which is protected from the direct weather
elements and direct sunshine. The best location is 4 to 8 feet above the ground with permanent shade and plenty of
fresh air to circulate around the sensor
b.
Display unit and outdoor sensor must be within 99 feet of each other.
c.
In order to maximize the wireless range, place units away from large metallic items, thick walls, metal surfaces or other
objects that may limit wireless communications.
d.
To prevent wireless interferences, place both units at least 3 feet away from electronic devices (EX: TV, computer,
microwave etc.).
Outdoor Sensor Function:
a.
Once the display unit has been set up and the channel synchronized with the outdoor sensor, the display unit will begin
the registration process. It can take up to 3 minutes to complete the registration, where the display unit will search for an
RF (Radio Frequency) signal from the outdoor sensor. The outdoor sensor signal strength will show the connection strength
to the outdoor sensor. If there are no bars or ifbars are not showing at its maximum strength (4 bars) try placing the
outdoor sensor or display unit elsewhere for better connection.
If the RF Signal was lost and not reconnected, the outdoor temperature and humidity level will begin to flash after 1
b.
hour of lost connection. If no connection was found after 2 hours only a dotted line ' - - - ' will be displayed in place of
the temperature and humidity level.
t t he RF registration, press and hold the "
To manually restar
c.
the RF signal for the next 3 minutes.
RF " bu tto n for 3 seconds. The display unit will now search for
Publicidad
