Publicidad
Idiomas disponibles
Idiomas disponibles
CLIP
PINCE
PINZA
WHEEL
HEIGHT
ADJUSTMENT
(1-1/4
IN. (32mm)
TO 3-1/2
IN. (89mm)
FIGURE
E
NOTE: Certain
types of grass or grass conditions
may require varying
the
height of the mower deck.
1. Before making
any adjustments,
turn mower off, wait for blade to stop,
and unplug mower.
2. Your mower features
the Black & Decker single lever wheel height
adjust system.
This system
will adjust all four wheels at the same time.
Mower adjusts
from 1-1/4 in. (32 mm) to 3-1/2 in. (89 mm) with six
increments
which are marked
on the mower.
3. Place your left hand on the height adjust handle E1 and your right
hand on the lower part of the main handle E2.
4. Pull height adjust handle
(El) away from mower, and re-set in the
desired
height adjust position.
Rotating the height adjust handle towards
the front of the mower lowers the cutting
height, and rotating towards
the
rear raises the cutting
height.
RECOMMENDED
APPROXIMATE
CUTTING
HEIGHT
The cutting
height should be in the higher recommendation
for warmer weather,
lower for shade areas and for the last mow before winter. Follow
the 1/3 rule, never cut off more than 1/3 of the total height of the grass. If lawn is too high to practice
this rule, raise the cut height before mowing
and then lower to desired
height and mow again in a clay or so.
OPERATING
INSTRUCTIONS
NOTE:
A mower is a major appliance
and should
not be operated
simultaneously
with
other major appliances
on the same house circuit.
Z_WARNING:
Make sure that other persons
and pets are at least 100 feet (30.48 m)
away.
Remove all rocks, sticks, wire, toys, bones, and other debris or items which might be
thrown by the rotating
blade.
ATTACHING
EXTENSION
CORD
TO MOWER
(FIGURE
F)
DO NOT connect
the extension
cord to power source until you have
finished
reading this manual and you are ready to start mowing.
1. The extension
cord must be polarized
and will only plug in one way,
orient the wide slot with the wide blade in the switch housing.
2.
Loop the extension cord (F1) and push the loop up through the hole in the
switch housing.
3.
Pull the extension
cord on the side of the loop that is plugged into the
switch
housing and remove all the slack in this section
of the extension
cord.
4.
Place the loop over the strain relief tab (F2) on the switch
housing
and
pull the extension
cord so the loop draws down around the strain relief
tab as shown in the detail. Double check to see that you did not loosen
the extension
cord.
Publicidad
