GE G193 Manual De Instrucciones página 6

About the control panel-Quick start guide,
Controls(Cont.)
Load Size
- Forconvenience, b estperformanceand optimalefficiency, s electPreciseFill. Thisselectionautomaticallyprovidesthe correctamount of water suitedto
the sizeandtype of load placedinthe unit. NOTE: T he washer will not fill with water when PreciseFifl is selected if the lid is opened.
- Ifyou preferto manualtysetectthe water levet, d epressthe Load Sizebuttonto highlightthe desiredselection. W hitePreciseFillisbest for mostloads
andgeneralwashing, y ou may want to manuallyselectthe load sizefor specialtyitems suchasbulky,lightweightcomfortersor pillows,whereyou
want to ensurea largerwater levetisapplied.Manualloadsizeselectionsshouldbe madefor wet items ptacedin the washer,suchas soakedtowetsor
garments.
- Somemodelsareequippedwith a "DeepFill"setting. Thisis idealforwashingbulkyitemsor when a maximumwater levelisdesired.
Power Press to "wake up" the display. If the display is active, press to put the washer into idle mode.
NOTE: Pressing POWERdoes not disconnect the appliance from the power supply.
Start PressStart to begin the cycle. NOTE:The lid must be closed for the washer to fill and the cycle to start. PressingStart again will
Pause the cycle and the Cycle indicator light will blink.
To continue the cycle, pressStart again or close the lid.If machine is paused more than 2/4 hours,the cycle will be cancelled. To stop the
cycle, hold the pad for 3 seconds. If water remains in the machine, select the Drain & Spin cycle to drain tub and spin water out of the
washer tub.
Raising the lid will stop agitation or spin action but does not pause the cycle.
eWash (on some models) - When the eWash pad is pressed,the cycle changes to its most energy efficient settings. The eMonitor
lights will now illuminate to indicate the relative efficiency of the modified cycle.
Display (on some models) - The display shows the approximate time remaining until the end of the cycle.
NOTE:The cycle time is affected by how long it takes the washer to fill. This depends on the water pressure in your home. The "smart" timer
"learns" the amount of time it takes to fill your washer and adjusts the total time accordingly.
In addition, this display will, "scroll" the washer status:
• bALANCING Start of rebalancing cycle to redistribute clothes. Stops after rebalancing is complete.
• dELAY When Delayed Wash is initiated. Replaced with estimated time when cycle starts.
End Endof current cycle.
FiLL For the first/45 seconds of a fill, the estimated end of cycle time is displayed. For the rest of the fill time, "FILL"is scrolled
until the fill completes.
LID Cycle stopped because lid is open. Closethe lid.
• PAUSE Cycle paused because the Start/Pause pad was pressed and the washer was set to Pause. PressStart pad again to
restart the cycle.
Indicator lights Five LED lights indicate the current washer status moving from left to right as the cycle progresses.