BELLOTA NIV30V Manual Do Utilizador página 39

Usage and LED
To turn the tool off, make sure that the lock switch located on the right side
of the laser is in the pendulum lock position. Once locked, keep the main
button pressed for 2 seconds until the level stops projecting.
Self-leveling mode
Place the laser level in position making sure the pendulum lock switch is in
the unlock position.
If the tool is outside the self-leveling range the laser beam will blink at 2Hz
until the tool is level. At this point, the laser level will stop blinking.
Manual mode
This function is activated by placing the pendulum lock switch in the locked
position, in this mode you can use the laser level to project straight or level
lines on any surface.
When deactivating the self-leveling function, the laser will blink every 5
seconds to warn that it is working in manual mode and the leveling may
not be exact.
General instructions
To turn on your laser level, press the main
button.
39