Tremmen Technology BSL-S60 Manual De Instrucciones página 8

Remote control controls and functions
1. Under normal circumstances, the remote control should be aimed
directly at the window where the unit's infrared sensor is located from
and around 5 meters within 30° angle.
2. When using the remote control, point the remote control at the receiving
window of the unit and make sure there are no obstacles between the remote
control and the unit.
3. If the unit's remote sensor receives direct sunlight, an error may occur. In
this case, place the unit in a place where it does not receive light.
4. Replace the remote control batteries when you notice a loss of range. If you notice that
the range of the remote control is reduced, replace the battery with a new one.
1. Mute
2. Mode: Mode selection.
3. Standby: On/Off.
4. Next Track / In FM I jump to a
higher frequency.
5. Previous track / In FM I jump to a lower
frequency.
6. Play / Pause / SCAN: Scanning FM
stations (In FM it is used to scan and
memorize all stations
found).
7. Volume (+) (-) Master.
8. EQ Effects Equalizations only in
USB / SD MP3.
9.Selection of USB or SD / SCN: Scanning
stations on Radio.
10. Selection of repeat modes (Rand, All,
Fold, One).
11. Number buttons.
* The photo is for reference and may
vary from the one supplied.
Connections and Switches
YoMain switch
Turn off the unit completely. Turn off this switch if you are not going to use
the unit for a long time.
Charging the Internal Battery of the unit
This unit has an internal battery to power it. Please recharge the
battery by connecting the AC/DC mains adapter to a power outlet.
The LED will illuminate Red during charging.
The LED will light Green when the battery is charged.
USB/SD functions
· Make sure your USB Pen-Drive or SD card (Not supplied)
is formatted as FAT32.
• Insert your SD / MMC card into the SD slot of the sound system with
the printed side facing back. · Insert your USB memory device into the
system USB port of this unit and playback will start automatically, as
long as it is loaded some Mp3 music file on your USB device.
· The unit should automatically detect the USB and play the first
track.
· If the USB does not start playback automatically, press the input
button (13) and select USB mode, and check that you do not have any
data files recorded that would prevent it from starting.
· If you want to pause the music, simply press the Play/Pause button.
· To select the next track, simply press the "Next" button
.
· To select the previous track, simply press the "Previous" button
.
· While listening to the tracks, you can select the type of pre-programmed
equalization "EQ" according to your desire.
Note:
1. Make sure the music files are MP3 format, or the music system will
not be able to read the files.