IKRA IPCS 46 Instrucciones De Servicio página 32

4. Others
Check for fuel leakage and loose fastenings and dam-
age to major parts, especially handle joints and guide
bar mounting. If any defects are found, make sure to
have them repaired before operating again.
Periodical service points
1. Cylinder fins
Dust clogging between the cylinder fins will cause
overheating of the engine. Periodically check and clean
the cylinder fins after removing the air cleaner and the
cylinder cover. When installing the cylinder cover, make
sure that switch wires and grommets are positioned cor-
rectly in place.
2. Fuel filter
a) Using a wire hook, take out the filter from the filler port.
GB | Operating Instructions
b) Disassemble the filter and wash with gasoline, or
1) Oiling port
2) Grease port
3) Sprocket
• After removing the filter, use a pinch to hold the end
• When assembling the filter, take care not to allow filter
3. Oil tank
With a wire hook, take out the oil filter through the filler
port and clean in gasoline. When putting the filter back
into the tank, make sure that it comes to the front right
corner. Also clean off dirt in the tank.
4. Spark plug
Clean the electrodes with a wire brush and reset the gap
to 0.65 mm as necessary.
5. Sprocket
Check for cracks and for excessive wear interfering with
the chain drive. If the wearing is found obviously, re-
place it with a new one. Never fit a new chain on a worn
sprocket, or a worn chain on a new sprocket.
6. Front and Rear dampers
1) Fuel filter
Replace if adhered part is peeled or crack is observed
on the rubber part.
13
replace with a new one if needed.
IMPORTANT
of the suction pipe.
fibers or dust inside the suction pipe.
2) Oil filter
Spark plug type:
NHSP LD L8RTF or
CDK L7RTC
1) Needle
bearing
2) Sprocket
3) Clutch drum
4) Washer
5) Clutch block