Descargar Imprimir esta página

Craftsman 919.167220 Manual Del Propietário página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

Contents
of Carton
1 - Air Compressor
2-
Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - Rubber Bumpers
2 - Screws, 1/4-20
x .75
Assemble
Wheels
Nut
Rubber
Feet
Tools Required
for Assembly
1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
1 - 3/8" socket or standard
screwdriver
Unpacking
1.
Remove all packaging leaving
the air compressor
on the pallet.
2.
Remove and discard the (4)
screws holding the air
compressor to the pallet.
Wheel
Shoulder Bolt
It will be necessary
to brace or support
one side of the air compressor
when installing the wheels because
the compressor
will have a
tendency
to tip.
1.
Attach wheels with shoulder
bolts and nuts as shown.
2.
Tighten securely. NOTE: The air
compressor
will sit level if the
wheels are properly installed.
N
The wheels and
handle do not
provide
adequate
clearance,
stability
or support
for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
It may be
necessary
to brace
or support
one side of the air
compressor
when removing
the
pallet because
the air compressor
will have a tendency
to tip.
3.
Carefully remove the air
compressor from the pallet.
Assemble Rubber Feet
1.
Attach rubber feet with the
screws provided as shown in
previous figure.
2.
Tighten securely.
D26543
10- ENG

Publicidad

loading