Publicidad
Idiomas disponibles
Idiomas disponibles
Performing repairs
may expose voltage sources,
moving
,
.
-
parts or compressed
air sources,
moving parts or
compressed
air sources.
Persona[ injury may occur. Prior to attempting
any repairs, unplug the air compressor
and bleed off all air tank air
pressure.
PROBLEM
CORRECTION
Excessive tank
Move On/Auto/Off
lever to
pressure - safety
the "OFF" position,
if the
valve pops off.
outfit does not shut off
contact a Trained Service
Technician.
Air leaks at
fittings.
Air leaks at or
inside check
valve.
Air leaks at
pressure switch
release valve.
Air leaks in air
tank or at air
tank welds.
Air leaks
between head
and valve plate.
CAUSE
Pressure switch does not
shut off motor when
compressor reaches
"cut-out"
pressure.
Pressure switch "cut-out"
too high.
Tube fittings are not tight
enough.
Check valve seat damaged.
Defective pressure switch
release valve.
Defective air tank.
Leaking seal.
Contact a Trained Service
Technician.
Tighten fittings where air can
be heard escaping. Check
fittings with soapy water
solution. Do Not
_hten.
A defective check valve
results in a constant air leak
at the pressure release valve
when there is pressure in the
tank and the compressor
is
shut off. Replace check
valve. Refer to the "To
Replace or Clean Check
Valve" in the "Service and
Adjustment"
section.
Contact a Trained Service
Technician.
Air tank must be replaced.
Do not repair the leak.
Do not drill into, weld or
otherwise
modify air tank
or it will weaken.
The tank
can rupture
or explode.
Contact a Trained Service
Technician.
21-ENG
D26543
Publicidad
