Publicidad
Idiomas disponibles
Idiomas disponibles
Closing force sensor SKS 02 - with closing force lugs SKB 07
Closing force range:
Ultimate load:
Jaw spacing for measurement:
Dimensions:
Jaw width:
Closing force sensor SKS 02 - with closing force lugs SKB 05
Closing force range:
Ultimate load:
Jaw spacing for measurement:
Dimensions:
Jaw width:
Legend / Components of Test Equipment CAL 02
(1) Dial gauge (depending on
version chosen)
(2) Case
(3) Closing force sensor (SKS 02)
Safety instructions
Symbols employed
Warning
Information on hazards that could give rise to bodily injury or damage to property.
Operation and checking steps must be carried out in the order given.
General
The Test Equipment CAL 02 is ‘state of the art’ and is safe. The gauge can give rise to residual dangers if it is used and
operated by untrained persons.
Persons charged with operating and maintaining the Test Equipment CAL 02 must have read and understood the
operating instructions and, in particular, the safety instructions.
The operating authority, not the manufacturer of the Test Equipment CAL 02, is responsible for any injury or damage to
persons or property caused by improper use.
Do not drop Test Equipment CAL 02
Only use the Test Equipment CAL 02 when it is perfect operating condition. Have defective parts replaced immediately.
Use only original OETIKER spare parts and accessories.
Setting, maintenance and repair work on Test Equipment CAL 02 should only be carried out by OETIKER. Only allow
specially trained persons to carry out setting and maintenance work. The operating instructions of the dial gauge also
apply and must be observed.
Function and operation
The Test Equipment CAL 02 is a manual tool for measuring the closing force (SK) by means of a closing force sensor
(SKS 02). It is suitable for use with OETIKER ME/EL pneumatic pincers with a pincer head for ear clamps, and
OETIKER HMK 01 manual pincers with force control. With special pincer heads, the appropriate calibration sets must
be used as detailed in our Tools catalogue.
The purpose of closing force tester OETIKER Test Equipment CAL 02 is to determine and set the closing force of
OETIKER installation tools. OETIKER ear-type clamps should be closed – with force priority – using a specified, uniform
closing force. This results in constant, reproducible tensile forces in the clamp material that are within permissible limits.
It avoids overloading of individual components, the parts being joined, and the clamp. The recommended closing forces
for the appropriate OETIKER product group are given in the relevant Technical Data Sheet.
08901805
(4) Hexagon key, 2.5 / 3mm A/F
(5) Measuring tip
(6) Closing force lugs
(7) Socket cap screw M3
Operating Instructions English
Edition 02.09
Operating Instructions
Test Equipment
OETIKER CAL 02
Optional (SKB07-set: item no. 13600059)
500 N – 4 500 N
6 000 N
6.5 mm +/- 0.5 mm
ca. 84 x 18 x 46 mm
7 mm
Optional (SKB05-set: item no. 13600060)
500 N – 2 500 N
3 000 N
6.5 mm +/- 0.5 mm
ca. 84 x 18 x 46 mm
5 mm
(8) Adjustment for dial gauge
(9) Contact pad for measuring tip
(10) Loctite 243 adhesive
(11) Socket cap screw M4 (12.9)
www.oetiker.com
5
Publicidad
