Publicidad
Idiomas disponibles
Idiomas disponibles
gap of the child car seat.
4. Place the lap belt section on the opposite side of the child car seat through
the red belt guide gap.
5. Ensure that the diagonal belt of the 3-point vehicl belt sits over the child' s
collar bone and not in front of their neck.
TIP: If necessary, adjust the headrest to ensure that the seat belt Is sitting
correctly on the child's shoulder.
For your child's safety, ensure that the following checks are carried out
before every journey:
•
The ISOFIX connectors are securely engaged in the anchors and the
indicators are both completely green.
•
The child car seat is sat up against the backrest of the vehicle seat.
•
The diagonal belt section of the 3-point vehicle belt and the lap belt
section on the side of vehicle seat buckle are passed through the red belt
guide gap.
•
The lap belt section on the opposite side to the vehicle seat buckle is
passed through the red belt guide gap.
•
The diagonal belt of the vehicle seat belt sits over the child's collar bone
and not in front of their neck.
•
Any lap strap must be worn low down, so that the pelvis is firmly engaged.
•
The 3-point vehicle belt is tight and not twisted at any point.
REMOVAL AND INSTALLATION OF THE 5-POINT
HARNESS
1 Removal of the 5-point harness
1. Press down on the central adjuster, and pull the shoulder straps
towards you, extending the 5-point harness as far as it will go. DO
NOT pull on the shoulder pads.
2. Pull the adjusting handle upwards, whilst pushing the headrest
downwards to the position of suitable position.
Turn the child car seat around so that the rear is facing you.
3. Open the rear cover board.
4. Place the webbing loops of the shoulder straps over the joint plate.
5. Close the rear cover board.
Turn the child car seat around so that the front is facing you.
1. Pull out the shoulder belts and shoulder pads from the headrest slots
in front of the headrest.
2. Take out the shoulder belts from the buckle.
EN
29
Publicidad
