Descargar Imprimir esta página

TCL MR453 Serie Manual De Instrucciones página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning
The appliance interior, including interior accessories, should be cleaned regularly.
Caution!
Remove and disconnect all power to the accessory before cleaning to avoid the dangers
of electric shock. To remove and disconnect all power, switch the appliance off and remove the
plug from the main outlet, or switch the unit off and turn off the circuit breaker or fuse. Never
clean the appliance with a steam cleaner as moisture could accumulate in electrical components,
causing electrical shock! Hot vapors can also damage plastic parts. The appliance must be
completely dry before turning it on and continuing use.
Important!
Ethereal oils and organic solvents can damage plastic parts, e.g. lemon juice or the
juice from an orange peel, butyric acid, and cleaners that contain acetic acid. Do not allow such
substances to come into contact the appliance parts. Do not use any abrasive cleaners.
• Do not allow such substances to come into contact the appliance parts.
• Do not use any abrasive cleaners
• Remove the food from the freezer. Store them in a cool place, well covered.
• Switch the appliance off and remove the plug from the mains, or switch off or turn out the
circuit breaker of fuse.
• Clean the appliance and the interior accessories with a cloth and lukewarm water. After
cleaning wipe with fresh water and rub dry.
• After everything is dry place appliance back into service.
Defrosting of the freezer
The freezer compartment will become progressively covered with frost. This should be removed.
Never use sharp metal tools to scrape off frost from the evaporator as you could damage it.
However when the ice becomes very thick on the inner liner complete defrosting should be carried
out as follows:
• Pull out the plug from the outlet
• Remove all stored food wrap it in several layers of newspaper and put it in a cool place.
• Keep the door open and placing a basin underneath the appliance to collect the defrost water.
• When defrosting is completed dry the interior thoroughly
• Replace the plug in the power outlet to run the appliance again.
Replace the lamp
Caution! Before replacing the lamp, shall disconnect the appliance from mains power supply.
Lamp specification is listed in rating label. Follow below process to replace the lamp:
1. Set the temperature regulation knob at number "0" to switch off
the appliance.
2. Unplug the appliance to make sure the appliance is disconnected
from main power supply.
3. Remove the screw of the lamp cover.
4. Pull the lamp cover out.
5. Unscrew the lamp.
6. Fit new lamp according to the opposite direction, then replace the
lamp cover and screw.
7. Plug in the appliance and regulate the knob to right position.
13

Publicidad

loading