Nostalgia Products Thermostar TSWCBLICDS35BK Instrucciones Y Recetas página 9

ASSEMBLY
Use EXTREME CAUTION when handling the appliance. When taking out
of package, it is recommended to lay the box safely on its side. The WATER
COOLER & ICE DISPENSER will be mostly assembled. Once unpacked and
standing upright, the Drip Tray Cover will need to be inserted.
LOCATION REQUIREMENTS:
1. Install in the area where it is protected from the elements including direct sun.
2. Install and use only on a hard, flat and level surface.
3. Do NOT place the dispenser inside an enclosed space or cabinet.
4. Position the dispenser no closer than 4 inches from the wall with at
least 4 inches clearance on the sides to permit free airflow.
WATER JUG INSTALLATION
Installing and replacing 3 or 5 gallon coolers (not
included) is a simple task. NOTE: Excessive weight
hazard - It is recommended to use two or more people
to move and install bottles. Failure to do so can result
in injury.
1. Open up the cabinet Door on the bottom.
2. Remove the water cap off of your standard-
sized 3 or 5 gallon water jug.
3. Place the Siphon Tube inside of the water jug so it's
touching the bottom. NOTE: When using 3 gallon
jugs, place the Siphon Pump into the jug, and then
slide the Collar down to the top of the water bottle.
4. Make sure the Collar fits securely over the
water jug top, ensuring no leakage.
5. Close the door.
NOTE: The Siphon Tube features a sliding Collar that accommodates both 3 and 5 standard-
sized water jugs. Make sure that the Collar fits securely over your water jug before use.
HOW TO OPERATE
WARNING: This unit is intended for water and ice made from water dispensing
only. Do NOT use other liquids. Do NOT use for other purposes. Warranty is void
if used with any other liquids such as coffee, tea, juices, beer or wine.
This dispenser has been designed to use water bottles with a 3
or 5 gallon capacity. DO NOT use alternative bottles.
Powering On:
1. Make sure you have found a proper location for your WATER COOLER &
ICE DISPENSER and have followed the steps to install a water jug.
2. Plug the cord into a properly grounded wall outlet.
WARNING: Always make sure that the cord is away from a water source.
3. After the machine has been plugged in, press the power button. The
Control Panel will beep and the Power Indicator light will remain on.
7
5 Gal. Water
Jug
3 Gal.
Water Jug