Publicidad
Idiomas disponibles
Idiomas disponibles
English
be thrown at you, or cause you to lose your balance
under pulling.
When cutting a branch that is under tension, be alert
to the risk of elastic return. When the tension of the
wood fibers is released, the branch, under a spring
effect, can hit the operator.
When transporting the chainsaw, hold the chainsaw
by the handle with the machine switched off and away
from body parts. When transporting or storing the
chainsaw, always cover the bar with the cap. Proper
handling of the chainsaw will reduce the likelihood of
accidental contact with the moving saw chain.
2.3. SAFETY OF THE WORK AREA
Keep the work area clean and work in good lighting.
Messy and dark areas cause accidents.
Do not operate this machine in explosive
atmospheres as well as in the presence of
flammable liquids, gases and dust. Electric
machines create sparks that can ignite dust or
fumes.
Keep curious and children away while operating this
machine. Distractions can cause you to lose control.
Make sure that children, people or animals do not
enter your work area.
2.4. ELECTRICAL SAFETY
Use only Garland batteries for this machine.
Use only the Garland charger to charge Garland
batteries. The use of a different battery or charger
may cause the battery to explode and risk of fire.
Be sure to connect the charger to an AC power
source with a voltage between 100 and 240 Volts
and a frequency of 50Hz to 60Hz.
The electrical plug on the charger of this machine
must match the base of the power outlet.
Never modify the plug in any way. Unmodified pins
and matching bases will reduce the risk of electrical
shock.
When using the battery charger, avoid body contact
with grounded surfaces such as pipes, radiators,
electric ranges, and refrigerators. There is an
increased risk of electric shock if your body is
grounded.
Do not expose this machine, charger or battery to
rain or wet conditions. The water that enters them
will increase the risk of electrical discharge.
Do not abuse the cord. Do not use the cord to carry,
lift or unplug the charger. Keep cord away from heat,
oil, sharp edges, or moving parts. Damaged or tangled
cords increase the risk of electric shock.
Never use this charger with a damaged cord or plug.
Before connecting the charger, check the plug and
cable for damage. If you discover any damage, send
your machine to a technical service for repair. If the
cord is damaged or broken, unplug immediately.
Damaged or tangled cords increase the risk of electric
shock.
Replacing the plug or power cord should always be
done by the manufacturer or its technical support
service. It is recommended to connect this charger to
a residual differential device whose tripping current is
less than or equal to 30mA.
Never use a damaged, non-compliant docking
station for this charger.
Disconnect the charger from the power supply when
not in use to prevent damage in case of mains
overload.
28/128
Publicidad
